Huawei FusionDC1000A - Setting Management System Parameters

4.7.3.1 Setting Management System Parameters
Procedure
Step 1 Apply for a xed IP address to the equipment room network administrator.
Step 2 Set the IP address, subnet mask, and default gateway on the ECC800-Pro WebUI.
Table 4-10 IP parameters
Path Parameter Default
Value
Setting
System
Settings >
System
Parameter
s >
Monitor IP
> WAN_1
IP 192.168.8.1
0
Set this parameter based on the IP
address assigned by the network
administrator.
Subnet
mask
255.255.25
5.0
Set this parameter based on the
subnet mask assigned by the network
administrator.
Default
gateway
192.168.8.1 Set this parameter based on the
default gateway address assigned by
the network administrator.
Step 3 Click Submit.
Step 4 Set management system communications parameters and authentication
password on the ECC800-Pro WebUI.
Table 4-11 Management system parameters
Path
Parameter Default
Value
Setting
System
Settings >
NMS
Application
> NetEco >
Communicat
ion
Parameters
Server IP 192.168.8.
11
IP address of the primary
management system server
NOTE
The management system IP address
and the ECC800-Pro IP address must be
congured in the same network to
ensure normal connection between the
management system and the ECC800-
Pro.
Port number 31220 31220
Network port
for link setup
WAN_1 WAN_1
FusionDC1000A Prefabricated All-in-One Data
Center
Commissioning Guide (IT Scenario) 4 Commissioning Core Devices
Issue 02 (2022-12-15) Copyright © Huawei Digital Power Technologies Co., Ltd. 61