Table 5-10 Setting device addresses
Address Toggle
Switch 1
Toggle
Switch 2
Toggle
Switch 3
Toggle
Switch 4
Toggle
Switch 5
Toggle
Switch 6
1 ON OFF OFF OFF OFF OFF
2 OFF ON OFF OFF OFF OFF
Step 4 Add the cabinet electronic clasp locks.
1. Log in to the ECC800-Pro WebUI as an administrator.
2. Create a cabinet view in Smart Module View on the home page.
3. Add a cabinet electronic clasp lock.
Table 5-11 Adding a cabinet electronic clasp lock
Path Parameter Setting
Choose System Settings
> Device Management
and click Add Device.
Device
Attribute
Cabinet Electronic Clasp Lock
Device Type Cabinet Electronic Clasp Lock
Connect To ECC800-Pro
Communicat
ions Port
COM2
Device
Address
Enter the actual device address of
the cabinet electronic clasp lock.
4. Click Test Connect to check whether the connection between the cabinet
electronic clasp lock and the ECC800-Pro is normal.
– If the connection is normal, click
Conrm. The connected devices are
displayed in the Number of connected devices list.
– If the connection is abnormal, check whether the device is properly
connected to the ECC800-Pro, whether both are running properly, and
whether the parameter settings are consistent with the device
parameters.
5. Repeat Step 4.3 and Step 4.4 to connect other cabinet electronic clasp locks.
Step 5 Commission the cabinet electronic clasp locks.
FusionModule500 Smart Mini Data Center
User Manual 5 Power-On Commissioning
Issue 01 (2020-11-30) Copyright © Huawei Technologies Co., Ltd. 131
To Next Page
Loading...