Bind the new optical cable in the same way as the existing optical cables. You can also
remove all existing cable ties and bind all optical cables again if necessary.
----End
7.2.6.6 Connecting a USB Device
Procedure
Step 1 Connect the USB device to a USB port of the server.
Figure 7-21 Connecting a USB device
----End
7.2.6.7 Connecting a Serial Cable
The rear panel of the server provides a standard RJ45 serial port (3-wire), which works as the
system serial port by default. You can set it as the iBMC serial port by using the iBMC CLI.
The serial port can be used as:
l System serial port to monitor the OS status
l iBMC serial port for debugging and fault locating
Procedure
Step 1 Connect the serial cable.
FusionServer Pro 2288H V5 Server
User Guide
7 Installation and Configuration
Issue 08 (2019-10-30) Copyright © Huawei Technologies Co., Ltd. 94
To Next Page
Loading...
