Huawei FusionServer Pro XH321 V5 - Page 110

Step 6 Install memory modules.
For details, see 8.4.14 Installing a Memory Module.
Step 7 Install M.2 SSDs.
For details, see 8.4.2 Installing an M.2 SSD.
Step 8 Install the TPM.
For details, see 8.4.16 Installing the TPM.
Step 9 Install the PCIe card.
For details, see 8.4.20 Installing a PCIe Card.
Step 10 Install the PCIe riser module.
For details, see 8.4.22 Installing a PCIe Riser Module.
Step 11 Install the screw-in RAID controller card.
For details, see 8.4.4 Installing the Screw-in RAID Controller Card.
Step 12 Install the supercapacitor if it is
congured.
For details, see 8.4.6 Installing the Supercapacitor.
Step 13 Install the air duct.
For details, see 8.4.24 Installing the Air Duct.
Step 14 Install the server node.
For details, see 8.3.4 Installing an XH321 V5.
Step 15 Power on the server node.
For details, see 8.3.1 Power-On Procedure.
Step 16 Check the indicator status. If the health status indicator is steady green, the server
node is running properly.
For details, see 2.1.2 Indicators and Buttons.
Step 17 To burn the product SN in the new mainboard, contact technical support.
NO TICE
If the product SN is not burnt in the new mainboard, the iBMC and OS cannot
obtain the product SN. This may aect the running of some services or the
monitoring and management on the device.
Step 18 After the mainboard is replaced, the LOM is replaced and the MAC address of the
LOM is changed. If the LOM is used for transferring data, you need to congure
the LOM data.
Step 19 After the mainboard is replaced, the iBMC and BIOS settings are restored to the
default settings of the new mainboard. Congure the iBMC and BIOS based on
service requirements.
FusionServer Pro XH321 V5 Server Node
Maintenance and Service Guide 8 Parts Replacement
Issue 17 (2021-03-09) Copyright © Huawei Technologies Co., Ltd. 101