Huawei HG8240 - Page 114

– Software Version: V1R002C00 (or V1R002C01)
(6) Click OK.
l Configure the multicast service.
The prerequisite for performing operations in the navigation tree is to navigate to the NE
Explorer of the OLT. To navigate to the NE Explorer of the OLT, do as follows: In the
Main Topology, double-click the required OLT in the Physical Root navigation tree; or
right-click the required OLT and choose NE Explorer from the shortcut menu.
1. Configuring the Information About the ETH Port of a GPON ONU
(1) Choose GPON > GPON ONU from the navigation tree.
(2) On the GPON ONU tab page, set the filter criteria to display the required GPON
ONUs.
(3) In the information list, right-click the ONT record where Frame, Slot, Port, and
ONU ID are set to 0, 2, 1, and 0 respectively and click the The Ont's UNI Port
Info tab in the lower pane.
(4) On the The Ont's UNI Port Info tab page, right-click the record where UNI
Type is set to ETH and UNI ID is set to 3, and choose Modifyfrom the shortcut
menu.
(5) In the dialog box that is displayed, set Default VLAN ID to 30.
(6) Click OK.
2. Configure a service VLAN on the OLT side.
A service VLAN is the VLAN used for the multicast service.
(1) Choose VLAN from the navigation tree.
(2) On the VLAN tab page, right-click and choose Add from the shortcut menu.
(3) In the dialog box that is displayed, set the parameters.
– VLAN ID: 1000
– Type: Smart VLAN
3 Configuration
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual
3-76 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 04 (2011-01-12)