Huawei HG8240 - Page 204

– Binding options: LAN3
(3) Click Apply to apply the configuration.
4. Enable DHCP replay.
(1) In the navigation tree, choose LAN > DHCP Server Configuration.
(2) In the right pane, click the check box of Enable DHCP L2Relay.
NOTE
If Bridge Type of the WAN port is set to PPPoE_Bridged, DHCP relay does not need to be
enabled. If Bridge Type is set to IP_Bridged, DHCP relay must be enabled.
(3) Click Apply to apply the configuration.
5. Save the configuration.
In the navigation tree, choose System Tools > Configuration File. In the right pane,
click Save Configuration to save the configuration.
l Configure the ONT on the U2000.
Layer 3 bridge mode is used for connecting the ONT to the upper-layer device and
parameters of a WAN port must be configured.
The following uses batch configurations of creating a value-added service profile of the
ONT as an example. To configure an ONT, on the GPON ONU tab page, select an ONT,
right-click, and choose Configure Value-Added Service from the shortcut menu.
3 Configuration
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual
3-166 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 04 (2011-01-12)