Huawei HG8240 - Figure 4-7 Pppoe Dialup Emulation; Querying the Physical State of a POTS Port

To Next Page

To Previous Page

Procedure

Step 1 In the Physical Map navigation tree on the Main Topology tab page, double-click the target

OLT, or select the target OLT, right-click, and choose NE Explorer.

Step 2 In the navigation tree, choose GPON > GPON ONU.

Step 3 On the GPON ONU tab page, set the search criteria to find the GPON ONU records.

Step 4 Select a record from the ONT list, right-click, and then choose PPPoE Test.

Step 5 In the dialog box that is displayed, set the related PPPoE emulation parameters, as shown in the

following figure.

Figure 4-7 PPPoE dialup emulation

Step 6 Click Start. After the test is complete, test results are displayed on the NMS.

----End

4.5.2 Querying the Physical State of a POTS Port

This topic describes how to verify whether a POTS port is in the normal state by querying the

physical state of the POTS port on the NMS.

4 Maintenance and Troubleshooting

EchoLife HG8240/HG8245/HG8247 GPON Terminal

Service Manual

4-14 Huawei Proprietary and Confidential

Issue 04 (2011-01-12)

Other manuals for Huawei HG8240