Step 1 Draw the detection area as in the normal configuration mode. Up to 8 areas are supported.
Step 2 Select Scheduled-Switch for Switch Day and Night Settings.
Figure 8-35 Day/Night Scheduled-Switch
Step 3 Select the start time and the end time for the switch timing.
Step 4 Select the area by clicking the area No.
Step 5 Slide the cursor to adjust the sensitivity and proportion of object on the area for the selected area
in the daytime.
Step 6 Slide the cursor to adjust the sensitivity and proportion of object on the area for the selected area
at night.
Step 7 Set the arming schedule and linkage method as in the normal configuration mode.
Step 8 Click
to save the settings.
----End
8.6.2 Configuring Video Tampering Alarm
You can configure the camera to trigger the alarm when the lens is covered and take alarm
response action.
Step 1 Enter the Tamper-proof Settings interface: Configuration > Advanced Configuration >
Events > Video Tampering.
Step 2 Check Enable Video Tampering checkbox to enable the video tampering detection.
Figure 8-36 Video Tampering Alarm
IPC6131-WD-A&6123-WDL-A&6232-IR&6212-
IR&6231-WD-VRZ&6332-MIR&6311-IR&6331-IR
User Guide 8 Network Camera Configuration
Issue 02 (2014-12-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
99
To Next Page
Loading...
