netHDD, please refer to 9.1 Configuring NAS Settings). You can also upload the captured
pictures to a FTP server.
Basic Settings
Step 1 Enter the Snapshot Settings interface: Configuration > Advanced Configuration > Events >
Snapshot.
Step 2 Check the Enable Timing Snapshot checkbox to enable continuous snapshot. Check the Enable
Event-triggered Snapshot checkbox to check event-triggered snapshot.
Step 3 Set the format of the picture, and only JPEG is supported for the moment.
Step 4 Set the resolution, which is the current resolution of the camera.
Step 5 Set the quality from the drop-down list. High, Medium, and Low are selectable.
Step 6 Set the interval according to your demand. Millisecond, second, minute, hour, and day are
selectable.
NOTE
500 ~ 60480000 millisencond, 1 ~ 604800 second, 1 ~ 10080 minute, 1 ~ 168 hour, or 1~7 day is selectable
for interval.
Step 7 Select the quality of the snapshot.
Step 8 Set the time interval between two snapshots.
Step 9 Click to save the settings.
----End
Uploading to FTP
You can follow instructions below to upload the snapshots to FTP.
Upload continuous snapshots to FTP
Step 1 Configure the FTP settings and check
checkbox in FTP Settings interface.
Please refer to 8.3.8 Configuring FTP Settings for more details to configure FTP parameters.
Step 2 Check the Enable Timing Snapshot checkbox.
----End
Upload event-triggered snapshots to FTP
Step 1 Configure the FTP settings and check checkbox in FTP Settings interface.
Please refer to 8.3.8 Configuring FTP Settings for more details to configure FTP parameters.
Step 2 Check checkbox in Motion Detection Settings or Alarm Input interface.
Please refer to Task 3: Set the Alarm Actions for Motion Detection in 8.6.1 Configuring
IPC6131-WD-A&6123-WDL-A&6232-IR&6212-
IR&6231-WD-VRZ&6332-MIR&6311-IR&6331-IR
User Guide
9 Storage Settings
Issue 02 (2014-12-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
114
To Next Page
Loading...
