c. Keep the mobile phone within 5 m from the Smart PCS. Otherwise, the
communication between them might be aected.
Procedure
Step 1 In the SUN2000 app, select a connection mode.
● The screenshots in this section correspond to the SUN2000 app 6.23.00.125 (Android).
● When the WLAN connection is used, scan the QR code of the WLAN module to access
the login screen.
● When the WLAN connection is used, the initial name of the WLAN hotspot is Adapter-
WLAN module SN and the initial password is Changeme. Use the initial password for
the rst login and change it immediately after login. To ensure account security, protect
the password by changing it periodically, and keep it secure. Your password might be
stolen or cracked if it is left unchanged for extended periods. If a password is lost,
devices cannot be accessed. In these cases, the Company shall not be liable for any loss
caused to the plant.
Figure 7-2 Selecting a connection mode
Step 2 Select the login user and enter the login password. The main menu screen is
displayed.
● When you log in to the system for the rst time, set the login password. To
ensure account security, protect the password by changing it periodically, and
keep it secure. Your password might be stolen or cracked if it is left unchanged
for extended periods. If a password is lost, devices cannot be accessed. In these
cases, the Company shall not be liable for any loss caused to the plant.
● You will be locked out for 10 minutes after ve consecutive failed password
attempts at an interval of less than 2 minutes.
LUNA2000-200KTL-H1 Smart Power Control System
User Manual 7 Power-On and Commissioning
Issue 08 (2024-01-23) Copyright © Huawei Technologies Co., Ltd. 67
To Next Page
Loading...