Figure 4-11 Connecting to a Huawei NMS
Step 8 Connect to a third-party NMS.
1. Select IEC104 or Modbus TCP based on the protocol used by the
SmartLogger to connect to the third-party NMS.
Figure 4-12 Connecting to a third-party NMS
2. Set related parameters by referring to "Setting Parameters for Connecting
to the Management System" (content related to a third-party NMS) in the
SmartLogger3000 User Manual
.
3. Send a command on the third-party NMS (for example, adjusting the settings
of Microgrid compatibility) and check whether the SmartLogger can respond
properly.
Step 9 Connect to third-party devices.
Figure 4-13 Connecting to third-party devices
Step 10 Click Finish.
Commercial and Industrial Microgrid Energy Storage
Solution
Quick Guide (With Third-Party Microgrid Central
Controller) 4 System Power-On and Commissioning
Issue 04 (2023-12-18) Copyright © Huawei Digital Power Technologies Co., Ltd. 33
To Next Page
Loading...
