● You are advised to use the SmartLogger WebUI.
● If Door Status Alarm is generated, check whether the cabinet door is open. If yes, close
the door.
● If ESC Communication Failure is generated, check whether communications cables are
connected correctly and whether the power supply is normal.
Step 2 Short-circuit the water sensor and check whether a water alarm is generated on
the SmartLogger WebUI or CMU WebUI:
● If a water alarm is generated, the water sensor is properly connected. In this
case, the water alarm will be cleared after the short circuit is removed.
● If no water alarm is generated, check whether the water sensor cable is
connected properly.
After the alarm is cleared, choose Monitoring > Running Param. > Fire
suppression > Starting up on the SmartLogger WebUI or CMU WebUI.
Figure 10-17 Restoring the power supply
Step 3 Check whether an alarm is generated for the Smart Rack Controller on the
SmartLogger WebUI or CMU WebUI. If an alarm is generated, handle the alarm by
referring to the handling suggestions in the alarm reference section.
----End
10.8 Setting the System Antitheft Function
Context
The antitheft function is supported only in the LUNA2000B V100R023C00SPC120
and later versions and is used with SmartLogger V300R023C00SPC172 and later
versions.
LUNA2000-(97KWH-1H1, 129KWH-2H1,
161KWH-2H1, 200KWH-2H1) Smart String ESS
User Manual 10 Commissioning the ESS (SmartLogger WebUI)
Issue 10 (2023-11-07) Copyright © Huawei Digital Power Technologies Co., Ltd. 154
To Next Page
Loading...