Select the firmware.
Upgrade result
Device status:
Blue: The device is in the maskrom state.
Green: The device is in the loader state.
Pink: The device is in the MSC state.
Red: The operation failed.
Erase Flash memory and
then perform upgrade.
In the MSC state, perform switching
before upgrade or repair.
Procedure
1. Insert MediaPad 7 Lite and enable it to enter the upgrade mode (as shown in the
preceding main window).
2. Select firmware.
3. Ensure that MediaPad 7 Lite is in the Rockusb state (Maskrom or Loader state).
4. Upgrade or repair MediaPad 7 Lite.
To Next Page
Loading...
