Table 4-2 Checklist for indicators on a controller
No. Indicator Status and Description
4 Link/Active/Mode
indicator of the SmartIO
port
l Blinking blue slowly (1 Hz): The interface
module is working in FC mode, and the port link
is down.
l Blinking blue quickly (2 Hz): The interface
module is working in FC mode, and data is being
transmitted.
l Steady blue: The interface module is working in
FC mode, the port link is up, and no data is being
transmitted.
l Blinking green slowly (1 Hz): The interface
module is working in ETH mode, and the port
link is down.
l Blinking green quickly (2 Hz): The interface
module is working in ETH mode, and data is
being transmitted.
l Steady green: The interface module is working in
ETH mode, the port link is up, and no data is
being transmitted.
l Steady red: The port is faulty.
l Off: The port is not powered on.
6
Power indicator of the
interface module/Hot
Swap button of the module
l Steady green: The interface module is running
properly.
l Blinking green: The interface module receives a
hot swap request.
l Steady red: The interface module is faulty.
l Off: The interface module is powered off or can
be hot-swappable.
10 Link/Active indicator of
the management network
port
l Steady green: The port is connected properly.
l Blinking green: Data is being transferred.
l Off: The port is connected abnormally.
12 Speed indicator of the
management network port
l Steady orange: Data is being transferred at the
highest rate.
l Off: The data transfer speed is lower than the
highest speed.
13 Running/Alarm indicator
of the backup power
module
l Steady green: The backup power module is fully
charged.
l Blinking green (1 Hz): The backup power
module is being charged.
l Blinking green (4 Hz): The backup power
module is being discharged.
l Steady red: The backup power module is faulty.
OceanStor 2600 V3
Product Description
4 Hardware Architecture
Issue 09 (2019-05-15) Copyright © Huawei Technologies Co., Ltd. 26
To Next Page
Loading...
