Huawei OceanStor 2600 V3 - Page 54

Module No. Indicator Status and Description
4 Alarm indicator of the
controller enclosure
l Steady red: An alarm whose
severity is major or higher is
generated on the storage system.
l Off: The storage system is
running properly.
5 Power indicator/Power
button of the controller
enclosure
l Steady green: The controller
enclosure is powered on.
l Blinking green (0.5 Hz): The
controller enclosure is being
powered on.
l Blinking green (1 Hz): The
controller enclosure is in the
burn-in test.
l Blinking green (2 Hz): The
controller enclosure is in the
operating system boot process, or
is being powered off.
l Off: The controller enclosure is
powered off or is in the standby
state.
Indicators on the Rear Panel
Figure 4-32 shows the indicators on the rear panel of a controller enclosure.
Figure 4-32 Indicators on the rear panel of a controller enclosure
1
Power indicator of
the interface
module/Hot Swap
button of the module
2 Link/Active/Mode
indicator of the
SmartIO port
OceanStor 2600 V3
Product Description
4 Hardware Architecture
Issue 09 (2019-05-15) Copyright © Huawei Technologies Co., Ltd. 46