Huawei OceanStor 2600 V3 - Page 56

Module No. Indicator Status and Description
2 Link/Active/
Mode
indicator of
the SmartIO
port
l Blinking blue slowly (1 Hz): The interface
module is working in FC mode, and the port
link is down.
l Blinking blue quickly (2 Hz): The interface
module is working in FC mode, and data is
being transmitted.
l Steady blue: The interface module is working in
FC mode, the port link is up, and no data is
being transmitted.
l Blinking green slowly (1 Hz): The interface
module is working in ETH mode, and the port
link is down.
l Blinking green quickly (2 Hz): The interface
module is working in ETH mode, and data is
being transmitted.
l Steady green: The interface module is working
in ETH mode, the port link is up, and no data is
being transmitted.
l Steady red: The port is faulty.
l Off: The port is not powered on.
Power
module
3 Running/
Alarm
indicator of
the power
module
l Steady green: The power supply is correct.
l Blinking green: The power input is normal but
the disk enclosure is powered off.
l Steady red: The power module is faulty.
l Off: No external power input is found.
Controller 4 Link/Active
indicator of
the
management
network port
l Steady green: The port is connected properly.
l Blinking green: Data is being transferred.
l Off: The port is connected abnormally.
5 Speed
indicator of
the
management
network port
l Steady orange: Data is being transferred at the
highest rate.
l Off: The data transfer speed is lower than the
highest speed.
6 Running/
Alarm
indicator of
the backup
power
module
l Steady green: The backup power module is
fully charged.
l Blinking green (1 Hz): The backup power
module is being charged.
l Blinking green (4 Hz): The backup power
module is being discharged.
l Steady red: The backup power module is faulty.
OceanStor 2600 V3
Product Description
4 Hardware Architecture
Issue 09 (2019-05-15) Copyright © Huawei Technologies Co., Ltd. 48