12
2g
(Optional) Installing disk modules
(1) Installing disk modules into a 2 U disk enclosure
Scenario 1 Installing disk modules into a disk enclosure
(2) Installing disk modules into a 4 U disk enclosure
(1) (2)
Scenario 2 Installing disk modules into a high-density disk enclosure
Install disk modules into controller enclosures in the same way.
To ensure well heat dissipation, insert disks in the sequence of disk slot IDs. If there is any vacant disk
slot, cover it with a filler panel.
NOTICE
To ensure well heat dissipation, insert coffer disks to slots of A0 to A3. Then insert disks from left to right
and from E0 to A14. If the disk module is not fully configured, cover filler panels over vacant disk slots.
NOTICE
2h
(Optional) Installing filler panels
If the cabinet is equipped with filler panels, skip this procedure.
To Next Page
Loading...
