Huawei OceanStor Dorado V3 Series

To Next Page

To Previous Page

Step 6 Put the removed power module into an ESD bag.

Step 7 Take the spare part out of its ESD bag.

Step 8 Insert the BBU into the spare part until it clicks into place, as shown in Figure 5-57.

Figure 5-57 Installing a BBU

Step 9 Open the handle of the spare part, insert the spare part into the empty slot, and close the

handle, as shown in Figure 5-58.

NOTE

The procedure for installing a DC power module is the same as that for installing an AC power module.

This step uses the AC power module as an example.

OceanStor Dorado V3 Series

Parts Replacement

5 Replacing FRUs

Huawei OceanStor Dorado V3 Series - Page 144