Huawei OceanStor Dorado V3 Series

To Next Page

To Previous Page

Step 4 Press the latch on the power module to release the handle and pull out the power module, as

shown in Figure 5-76.

NOTE

The procedure for removing a DC power module is the same as that for removing an AC power module.

This step uses the AC power module as an example.

Figure 5-76 Removing an AC power module

Step 5 Put the removed power module into an ESD bag.

Step 6 Take the spare part out of its ESD bag.

Step 7 Open the handle of the spare part, insert the spare part into the empty slot, and close the

handle, as shown in Figure 5-77.

NOTE

The procedure for installing a DC power module is the same as that for installing an AC power module.

This step uses the AC power module as an example.

OceanStor Dorado V3 Series

Parts Replacement

5 Replacing FRUs

Huawei OceanStor Dorado V3 Series - Page 160