Huawei OceanStor Dorado V3 Series

To Next Page

To Previous Page

You can proceed to next steps only when all items pass the pre-replacement check and the

replacement page is displayed. If any item fails, rectify the fault as prompted.

Step 2 Wear an ESD wrist strap.

Step 3 Remove a fan module, as shown in Figure 5-96.

1. Press the latch on the panel to open the panel.

2. Press the latches on the fan module to pull out the fan module.

Figure 5-96 Removing a fan module

Step 4 Put the removed fan module into an ESD bag.

Step 5 Take the spare part out of its ESD bag.

Step 6 Insert the spare part into the empty slot until it clicks into place, as shown in Figure 5-97.

OceanStor Dorado V3 Series

Parts Replacement

5 Replacing FRUs

Huawei OceanStor Dorado V3 Series - Page 182