Huawei OceanStor Dorado V3 Series

To Next Page

To Previous Page

Figure 5-105 Removing a power module

Step 4 Put the removed power module into an ESD bag.

Step 5 Take the spare part out of its ESD bag.

Step 6 Open the handle of the spare part, insert the spare part into the empty slot, and close the

handle, as shown in Figure 5-106.

Figure 5-106 Installing a power module

Step 7 Wait about one minute and check the status of the Running/Alarm indicator on the power

module to determine whether the power module is successfully installed. Figure 5-107 shows

the location of the Running/Alarm indicator.

OceanStor Dorado V3 Series

Parts Replacement

5 Replacing FRUs

Huawei OceanStor Dorado V3 Series - Page 193