Huawei OceanStor Dorado V3 Series

To Next Page

To Previous Page

Figure 5-119 Removing a disk module

2. Hold the ejector lever, and pull out the disk module for about 3 cm (1.18 in.). See step

(2) in Figure 5-119. Wait for at least 30 seconds until the disk module stops working.

Then remove the disk module from the quorum server. See step (3) in Figure 5-119.

3. Place the removed disk module in an ESD bag.

Step 2 Install the spare part.

1. Take the spare part out of its ESD bag.

2. Fully raise the ejector lever and push the spare part into the chassis along the guide rails

until it does not move. See step (1) in Figure 5-120.

OceanStor Dorado V3 Series

Parts Replacement

5 Replacing FRUs

Huawei OceanStor Dorado V3 Series - Page 205