Figure 5-122 Installing the quorum server
3. When the two mounting ears on the spare part contact the mounting bars on the rack,
tighten the captive screws on the mounting ears to secure the spare part.
Step 4 Connect the cables and power on the spare part.
Step 5 After the spare part is powered on, reinstall and configure the quorum server software.
NOTE
For details, see the BC&DR Solution Product Documentation (Active-Active DCs).
----End
Follow-up Procedure
Log in to the quorum server, run the qsadmin command to go to the configuration page of the
quorum server software, and run the show server_ip command to check whether the
connections between the quorum server and storage devices are in Established state.
Q2qumrom:~ # qsadmin
start main!
Waiting for connecting to server...
admin:/>show server_ip
Index Server IP Server Port
----- --------------- ---------------
1 192.168.6.31 30002
2 192.168.7.31 30002
Index Local IP Local Port Remote IP Remote
Port State
----- --------------- --------------- ---------------
--------------- ---------
0 192.168.6.31 30002 192.168.6.17
44510 Established
1 192.168.6.31 30002 192.168.6.18
OceanStor Dorado V3 Series
Parts Replacement
5 Replacing FRUs
Issue 05 (2019-01-30) Copyright © Huawei Technologies Co., Ltd. 201
To Next Page
Loading...
