Huawei OceanStor S2600 - Page 117

Keyword and Value Description Default Value
-i port ID The ID of an FC host port.
The value ranges from 0 to 3.
l S2600F: Each host port
module is configured with
four FC host ports. From
left to right, the host ports
are numbered 0, 1, 2, and
3 in sequence.
l S2600C: Each host port
module is configured with
two FC host ports and two
iSCSI host ports. From left
to right, the FC host ports
are numbered 0 and 1 in
sequence.
None.
Modes
Normal mode.
Level
Super administrator level, administrator level and guest level.
Usage Guidelines
The command applies to FC host ports on the controller of the storage device.
l The command showfps is used to query the rates of all FC host ports.
l The command showfps -c controller ID -i port ID is used to query the rate of a specified
FC host port on a controller.
NOTE
The command can be used only when the storage system uses the S2600F or S2600C controller enclosure.
Example
Query the current rates of the FC host ports.
OceanStor: admin> showfps
Controller FCPort ID Speed
A 0 4G
A 1 4G
A 2 4G
A 3 4G
B 0 4G
B 1 4G
B 2 4G
B 3 Auto
OceanStor S2600 Storage System
Command Reference 5 Device Management Commands
Issue 07 (2010-05-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-25