Huawei OceanStor S2600 - Showsasmode

Usage Guidelines
The command chgfps can be used only when the storage system uses the S2600F or S2600C
controller enclosure.
Example
On controller A, change the rate of the FC host port 0 to 2 Gbit/s.
OceanStor: admin> chgfps -c a -i 0 -s 2
If change the speed online, this operation will lead to interrupt the service!
Do you want to continue? y or n: y
5.13.3 showsasmode
Function
The command showsasmode is used to query the information about Serial Attached SCSI (SAS)
host ports.
Format
showsasmode [-c controller ID -i port ID]
Parameters
Keyword and Value
Description Default Value
-c controller ID The controller ID. The value
is A or B, and is case
insensitive.
None.
-i port ID The ID of a mini SAS host
port. The value ranges from 0
(or 00) to 3 (or 03). 0 (or 00)
and 1 (or 01) indicate targets.
2 (or 02) and 3 (or 03)
indicate initiators.
None.
Modes
Normal mode.
Level
Super administrator level, administrator level and guest level.
Usage Guidelines
When using this command, note the following items:
OceanStor S2600 Storage System
Command Reference 5 Device Management Commands
Issue 07 (2010-05-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-27