51
Notes on Usage
When you put the product in your pocket or
bag, take care so that the display does not
come in contact with metal objects or other
hard objects, as it may cause scratching or
damage. Doing so might cause scratching
or damage. Be aware that any metal or
other hard cell phone strap that comes into
contact with the display may scratch or
damage them.
When suddenly brought into a warm place
from a cold place, or when in a humid
location, or when used where temperature
suddenly changes (e.g. near the air discharge
port of an air conditioner), water droplets (i.e.
condensation) sometimes are formed inside
the product. Note that when used under
conditions such as this, the humidity might
cause corrosion or a fault.
While writing/reading data to/from a microSD
memory card, do not subject the product
to vibration or impact, or turn o the power.
Doing so may cause data loss or malfunction.
Do not cover the illuminance sensor with your
nger or put a sticker on it. Doing so may
hinder the sensor for detecting the ambient
light level and functioning correctly.
Do not put a sticker, etc. on the proximity
sensor. Doing so may cause the sensor to
malfunction and make the display always
turned o while receiving a call or during a
call.
Use the product with the au IC Card/microSD
memory card tray closed. If the tray is
open, dirt or water may get inside, causing
malfunction.
To Next Page
Loading...
