Huawei P50 Pocket - Audio Control Panel

Measure Volume
On the AR Measure screen, go to Objects > or touch Volume. Both automatic and
manual measurements are supported.
• If the icon cannot be found in the viewnder, it means that your phone does not
support automatic volume measurements.
• Currently, only the volume of cubes and cuboids can be measured.
• Make sure the object is not placed against a wall and there is a distance of 1 to 1.5 m
(3.3 to 5 ft.) between your phone and the object.
Manually measure volume
1 If your phone supports automatic measurements, touch to disable auto mode rst.
Frame the surface on which the object is resting in the viewnder and slowly move your
phone to locate the plane.
2 When the plane is identied, move your phone to point at the object's bottom edge
and touch
to add a starting point.
3 Move your phone slowly so that travels along the long edge of the object until it
reaches the end. Then touch .
4 Move your phone to create a frame for the bottom of the object. When the frame
matches the bottom length and width of the object, touch .
5 Move your phone to create a frame for the whole object. When the frame matches the
size of the whole object, touch .
Your phone will automatically display the result.
6 Drag the tips of the object to ne-tune the measurement result.
Automatically measure volume
1 On a phone that supports automatic measurements, touch and make sure that auto
mode is enabled. Frame the object in the viewnder and slowly move your phone to
locate the plane.
2 When your phone identies the plane and recognizes the object, a frame will be displayed
automatically. Then touch .
Your phone will automatically display the result.
3 Drag the tips of the object to ne-tune the measurement result.
Audio Control Panel
Smart Features
62