Huawei PDU8000 - Installing the Combiner Cabinet; Installing the Combiner Cabinet (Concrete Floor)

To Next Page

To Previous Page

5 Installing the Combiner Cabinet

5.1 Installing the Combiner Cabinet (Concrete Floor)

Procedure

Step 1 Mark the positions for installing expansion bolts based on the marking-o

template.

Figure 5-1

Marking-o template (unit: mm)

Step 2 Drill holes at the marked positions using a hammer drill and install expansion

bolts.

1. Use a hammer drill to drill holes at the four marked positions. Ensure that the

depth of each hole ranges from 52 mm to 60 mm and all holes are of the

same depth. Use a vacuum cleaner to clean up dust inside and outside the

drilled holes.

2. Slightly tighten expansion bolts to prevent the expansion sleeves from

uttering. Then, hammer the expansion bolts into the holes vertically until the

at washers are ush with the oor.

3. Partially tighten the expansion bolts clockwise.

4. Loosen the bolts counterclockwise and remove the at washers and spring

washers.

PDU8000 DC Combiner Cabinet

Quick Guide 5 Installing the Combiner Cabinet

Other manuals for Huawei PDU8000