Huawei PDU8000 - 3.4 Features

Figure 5-6 Installing front and rear anchor bae plates
3. Clamp the anchor bae plates on the sides into those on the front and rear.
Figure 5-7 Installing side anchor
bae plates
----End
5.2 Installing the Combiner Cabinet (ESD Floor)
Context
A support is required when the combiner cabinet is installed on an ESD oor. The
support height depends on the height between the ground and the ESD oor.
Procedure
Step 1 Adjust the anchor bolts of the combiner cabinet using an adjustable wrench until
the castors hang in the air.
Step 2 Lift the combiner cabinet onto the support and align the cabinet mounting holes
with the support mounting holes.
Step 3 Adjust the anchor bolts of the combiner cabinet using an adjustable wrench, and
level the cabinet with a level.
PDU8000 DC Combiner Cabinet
Quick Guide 5 Installing the Combiner Cabinet
Issue 02 (2022-08-10) Copyright © Huawei Digital Power Technologies Co., Ltd. 15