● Wrench an anchor bolt clockwise to elevate a cabinet foot, or wrench an anchor bolt
counterclockwise to lower it. The cabinet feet can be adjusted within a range of 0–8
mm.
● To prevent cabinet tilting, adjust all the feet at the four corners instead of one foot.
● Do not remove anchor bolts, because this work brings you only a great deal of
reworking.
Figure 5-8 Leveling the combiner cabinet
(1) Leveling foot (2) Level
Step 4 Insert bolts into the mounting holes in the combiner cabinet and support, and
partially tighten the bolts.
Figure 5-9 Partially tightening bolts
Step 5 Use a socket wrench to tighten the bolts in diagonal order.
Step 6 Install anchor bae plates for the combiner cabinet.
1. Remove a total of four door sill fasteners from the front and rear.
PDU8000 DC Combiner Cabinet
Quick Guide 5 Installing the Combiner Cabinet
Issue 02 (2022-08-10) Copyright © Huawei Digital Power Technologies Co., Ltd. 16
To Next Page
Loading...
