Huawei Pura 70 - Biometrics & Password

Disable App 
If you do not want to be disturbed by  from an app, perform either of the
following:
• After you receive a  from the app, swipe left on it in the  panel, and
go to
> Disable .
• Go to Settings >  & status bar, locate and touch the app for which you want
to disable  then disable Allow .
• Go to Settings >  & status bar > Manage all, and turn  the switch next to
the app.
Set the Status Bar to Simple Display
Go to Settings >  & status bar > Status bar, and enable Simple display. After
doing so, only the following frequently-used icons will display on the phone status bar by
default: time, Wi-Fi network, mobile signal, and battery level.
Biometrics & Password
Set Fingerprints
You can enroll a  and then use it to unlock the screen and access your Safe, App
Lock, and more.
Add a Fingerprint
1 Go to Settings > Biometrics & password > Fingerprint ID, and follow the onscreen
instructions to set or enter the lock screen password.
2 Touch New  or New rear  (depending on your device model) to
begin enrolling your 
3 Place your  on the  sensor. When you feel a vibration, lift your 
and then press down again. Move your  around until the entire  is
captured, and follow the onscreen instructions to complete the enrollment.
You can now place your  on the  sensor to unlock the screen.
Rename or Delete a Fingerprint
1 Go to Settings > Biometrics & password > Fingerprint ID and enter your lock screen
password.
2 In the Fingerprint list section, touch an enrolled  to rename or delete it.
Fingerprint 
Fingerprint  allows you to match your  with the enrolled 
1 Go to Settings > Biometrics & password > Fingerprint ID and enter the lock screen
password.
Settings
127