(2) Configure a port to allow frames with the specified VLAN ID to pass through.
(3) Associate ports with VLANs.
After receiving a frame associated with a specified protocol, the system automatically
assigns the VLAN ID associated with the protocol to the frame.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
A VLAN is created, and the VLAN view is displayed. If the specified VLAN has been created,
the VLAN view is directly displayed.
The VLAN ID ranges from 1 to 4094. If VLANs need to be created in batches, run the vlan
batch { vlan-id1 [ to vlan-id2 ] } &<1-10> command to create VLANs in batches, and then run
the vlan vlan-id command to enter the view of a specified VLAN.
Step 3 Run:
protocol-vlan [ protocol-index ] { at | ipv4 | ipv6 | ipx { ethernetii | llc | raw
| snap } | mode { ethernetii-etype etype-id1 | llc dsap dsap-id ssap ssap-id | snap-
etype etype-id2 } }
A protocol is associated with a VLAN and the protocol template is specified.
l The optional parameter protocol-index specifies the protocol template index.
The protocol template is determined by the protocol type and encapsulation format. A
protocol VLAN can be defined by a protocol template.
l When configuring the source and destination service access points, note the following points:
– dsap-id and ssap-id cannot be both set to 0xaa.
– dsap-id and ssap-id cannot be both set to 0xe0, which corresponds to the Logical Link
Control (LLC) encapsulation format for IPX packets.
– dsap-id and ssap-id cannot be both set to 0xff, which corresponds to the RAW
encapsulation format for IPX packets.
Step 4 Configure the port type and features.
1. Run the interface interface-type interface-number command to enter the view of the port
to be configured to allow frames with the specified VLAN ID to pass through.
2. Run the port link-type hybrid command to set the port type to hybrid.
By default, the port type is hybrid.
3. Run the port hybrid untagged vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all } command
to allow frames with the specified VLAN ID to pass through.
4. Run:
protocol-vlan vlan vlan-id { all | protocol-index1 [ to protocol-index2 ] }
[ priority priority ]
The port is associated with the VLAN.
l The parameter vlan-id specifies the ID of a VLAN configured based on a protocol.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 3 VLAN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
84
To Next Page
Loading...
