The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
port link-type access
The link type of the interface is set to access.
Step 4 Run:
quit
Return to the system view.
Step 5 Run:
vlan vlan-id
A sub-VLAN is created and the sub-VLAN view is displayed.
Step 6 Run:
port interface-type { interface-number1 [ to interface-number2 ] } &<1-10>
A port is added to the sub-VLAN.
----End
3.6.3 Creating a Super-VLAN
A super-VLAN consists of several sub-VLANs. No physical port can be added to a super-VLAN,
but a VLANIF interface can be configured for the super-VLAN and an IP address can be assigned
to the VLANIF interface.
Context
NOTE
Before configuring a super-VLAN, ensure that sub-VLANs have been configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
A VLAN is created, and the VLAN view is displayed.
The VLAN ID of a super-VLAN must be different from every sub-VLAN ID.
Step 3 Run:
aggregate-vlan
A super-VLAN is created.
A super-VLAN cannot contain any physical interfaces.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 3 VLAN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
98
To Next Page
Loading...
