Huawei quidway s7700 - Configuring a VLANIF Interface for an Mvlan

Do as follows on the device that requires an mVLAN:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
The VLAN view is displayed.
Step 3 Run:
management-vlan
An mVLAN is configured.
An mVLAN cannot be configured as a multicast VLAN, control VLAN of RRPP, or control
VLAN of SEP.
Only a trunk or hybrid port can be added to an mVLAN.
After the undo management-vlan command is used for an mVLAN, the mVLAN becomes an
ordinary VLAN, to which access, trunk, or hybrid ports can be added.
----End
3.9.3 Configuring a VLANIF Interface for an mVLAN
You need to use the IP address of the VLANIF interface corresponding to an mVLAN to telnet
to a management switch to manage attached devices.
Do as follows on the device that requires an mVLAN:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
A VLANIF interface is created and the VLAIF interface view is displayed.
The ID of the VLANIF interface must be the ID of a configured mVLAN.
Step 3 Run:
ip address ip-address { mask | mask-length } [ sub ]
After assigning an IP address to the VLANIF interface, you can run the telnet command to log
in to a management switch to manage attached devices.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 3 VLAN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
114