Huawei quidway s7700 - Example for Implementing Communication between Vlans through VLAN Switching

area 0.0.0.0
network 10.10.10.0 0.0.0.255
network 30.30.30.0 0.0.0.255
#
return
Configuration file of Switch B
#
sysname SwitchB
#
router id 2.2.2.2
#
vlan batch 30
#
interface Vlanif30
ip address 30.30.30.2 255.255.255.0
#
interface GigabitEthernet1/0/1
port link-type trunk
port trunk allow-pass vlan 30
#
interface GigabitEthernet1/0/2.1
control-vid 100 dot1q-termination
dot1q termination vid 10
ip address 20.20.20.1 255.255.255.0
arp broadcast enable
#
ospf 1
area 0.0.0.0
network 20.20.20.0 0.0.0.255
network 30.30.30.0 0.0.0.255
#
return
3.12.9 Example for Implementing Communication Between VLANs
Through VLAN Switching
Networking Requirements
As shown in Figure 3-18, GE 1/0/1 and GE 1/0/2 of the Switch are connected to the uplink
interfaces of Switch A and Switch B respectively.
The downlink interfaces of Switch A and Switch B are added to VLAN 10 and VLAN 20
respectively.
It is required that PCs in VLAN 10 and PCs in VLAN 20 should be able to communicate with
each other.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 3 VLAN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
140