5 QinQ Configuration
About This Chapter
This chapter describes the basic knowledge, methods, and examples for configuring QinQ.
5.1 Concept of QinQ
This section describes the concept of QinQ.
5.2 QinQ Features Supported by the S7700
This section describes the QinQ features supported by the S7700.
5.3 Configuring QinQ on an Interface
This section describes how to configure the interface type, the protocol used by the outer VLAN
tag, and the interface-based QinQ.
5.4 Configuring Selective QinQ
This section describes how to configure the interface type, the outer VLAN ID, and selective
QinQ.
5.5 Configuring Flow-based Selective QinQ
This section describes how to set the interface type, the packet matching rule, the outer VLAN
tag added to received packets, and enable the traffic policy to implement flow-based selective
QinQ.
5.6 Configuring VLAN Stacking Based On the VLAN Priority
This section describes how to configure VLAN stacking based on the VLAN priority.
5.7 Setting the Protocol Type in the Outer VLAN Tag
This section describes how to set the protocol type in the outer VLAN tag on an interface.
5.8 Adding Double VLAN Tags to Untagged Packets
This section describes how to set the interface type, add an interface to the VLAN specified by
the outer tag of packets, and add double VLAN tags to untagged packets.
5.9 Connecting Sub-interfaces to a VLL Network
This section describes how to connect sub-interfaces of a PE to a VLL network so that CEs can
communicate with each other.
5.10 Connecting Sub-interfaces to a VPLS Network
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
188
To Next Page
Loading...
