Huawei quidway s7700 - Configuring a Traffic Policy; Applying the Traffic Policy

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
traffic behavior behavior-name
A traffic behavior is created and the traffic behavior view is displayed.
Step 3 Run:
nest top-most vlan-id vlan-id
The S7700 is configured to add an outer VLAN tag with the specified VLAN ID to the packets
matching the traffic classifier.
You must specify an existing VLAN ID on the S7700 in this command. You do not need to
create the VLANs specified by the original VLAN tags of received packets.
----End
5.5.5 Configuring a Traffic Policy
Context
Do as follows on the S7700 where you need to configure selective QinQ.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
traffic policy policy-name
A traffic policy is created and the policy view is displayed.
Step 3 Run:
classifier classifier-name behavior behavior-name
The traffic classifier is bound to the traffic behavior in the traffic policy.
----End
5.5.6 Applying the Traffic Policy
Context
Do as follows on the S7700 where you need to configure selective QinQ.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
197