Huawei quidway s7700 - Optional) Setting the Duplex Mode; Optional) Setting the Rate of an Interface

1.3.4 (Optional) Setting the Duplex Mode
Context
Do as follows on the S7700 where you need to set the duplex mode of interfaces.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The Ethernet electrical interface view is displayed.
Step 3 Run:
undo negotiation auto
The auto-negotiation mode is disabled on the Ethernet electrical interface.
Step 4 Run:
duplex { full | half }
The duplex mode is set for the Ethernet electrical interface.
By default, the duplex mode of an Ethernet electrical interface is full-duplex when auto-
negotiation is disabled on the interface.
----End
1.3.5 (Optional) Setting the Rate of an Interface
Context
Do as follows on the S7700 where you need to set the rate of interfaces.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
undo negotiation auto
The auto-negotiation mode is disabled on the interface.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 1 Ethernet Interface Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5