Huawei quidway s7700 - Creating a VLL Connection; Checking the Configuration; Connecting Sub-Interfaces to a VPLS Network

The system view is displayed.
Step 2 Run:
interface interface-type interface-number.subinterface-number
The view of the PE sub-interface connected to the CE is displayed.
Step 3 Run:
qinq stacking vid vlan-id1 [ to vlan-id2 ] pe-vid vlan-id3
VLAN stacking is configured on the sub-interface.
----End
5.9.7 Creating a VLL Connection
You need to create VLL connections on the CE, PE, and P.For details, see "VLL Configuration"
in the Quidway S7700 Smart Routing Switch Configuration Guide - VPN.
You can create the following types of VLL connections on a sub-interface:
l SVC remote connection
l Kompella local connection
l Kompella remote connection
l Martini remote connection
5.9.8 Checking the Configuration
Procedure
l Run the display dot1q information termination [ interface interface-type interface-
number [.subinterface-number ] ] command to check information about a dot1q sub-
interface.
l Run the display qinq information termination [ interface interface-type interface-
number [.subinterface-number ] ] command to check information about a QinQ sub-
interface.
l Run the display vll ccc [ ccc-name | type { local | remote } ] command to check information
about a CCC connection.
l Run the display mpls static-l2vc command to check information about an SVC L2VPN
VC.
l Run the display mpls l2vc command on the PE to check information about the Martini
VLL on the local PE.
l Run the display mpls l2vc remote-info command on the PE to check information about
the Martini VLL on the remote PE.
----End
5.10 Connecting Sub-interfaces to a VPLS Network
This section describes how to connect sub-interfaces of a PE to a VPLS network so that CEs
can communicate with each other.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
208