Huawei quidway s7700 - Example for Connecting Dot1 Q Sub-Interfaces to a VPLS Network

area 0.0.0.0
network 3.3.3.9 0.0.0.0
network 10.2.2.0 0.0.0.255
#
return
l Configuration file of Switch2
#
sysname Switch2
#
vlan batch 100
#
interface GigabitEthernet2/0/0
port hybrid tagged vlan 100
#
interface GigabitEthernet1/0/0
port hybrid untagged vlan 100
port vlan-stacking vlan 10 stack-vlan 100
#
return
l Configuration file of CE2
#
sysname CE2
#
vlan batch 10
#
interface Vlanif 10
ip address 100.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 10
#
return
5.12.11 Example for Connecting Dot1q Sub-interfaces to a VPLS
Network
Networking Requirements
As shown in Figure 5-11, VPLS is enabled on PE1 and PE2. CE1 is connected to PE1 and CE2
is connected to PE2. CE1 and CE2 belong to the same VSI. LDP is used as the VPLS signaling
protocol to set up the PW and Martini VPLS is configured to enable CE1 and CE2 to
communicate with each other.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
266