Huawei quidway s7700 - Example for Configuring the Dot1 Q Sub-Interface to Access an L3 VPN

mpls ldp
#
mpls ldp remote-peer 1.1.1.9
remote-ip 1.1.1.9
#
interface Vlanif30
ip address 169.1.1.2 255.255.255.0
mpls
mpls ldp
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 30
port hybrid tagged vlan 30
#
interface GigabitEthernet2/0/0
#
interface GigabitEthernet2/0/0.1
control-vid 2000 qinq-termination
qinq termination pe-vid 100 ce-vid 10
l2 binding vsi a2
#
interface LoopBack1
ip address 3.3.3.9 255.255.255.255
#
ospf 1
area 0.0.0.0
network 3.3.3.9 0.0.0.0
network 169.1.1.0 0.0.0.255
#
return
5.12.16 Example for Configuring the Dot1q Sub-interface to Access
an L3VPN
Networking Requirements
As shown in Figure 5-16, CE1 and CE3 belong to VPN-A and CE2 and CE4 belong to VPN-
B. The VPN target of VPN-A is 111:1, and VPN target of VPN-B is 222:2. The users in different
VPNs cannot communicate with each other.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
301