Huawei quidway s7700 - Configuration Examples; Example for Configuring GVRP

Procedure
Step 1 Run the reset garp statistics [ interface { interface-type interface-number [ to interface-type
interface-number ] }&<1-10> ] command in the user view to clear statistics about GARP on the
specified interfaces.
----End
6.5 Configuration Examples
This section provides configuration examples of GVRP.
6.5.1 Example for Configuring GVRP
Networking Requirements
As shown in Figure 6-2, a branch of company A communicates with the headquarters through
Switch A and Switch B. To simplify the configuration, you need to enable GVRP on all switches
of company A and set the registration mode to normal on interfaces of these switches.
Company B communicates with company A through Switch B and Switch C. To configure
switches of company B to transmit packets of only VLANs of company B, you need to enable
GVRP on all switches of company B and set the registration mode to fixed on the interfaces
connected to switches of company A.
Figure 6-2 Networking for configuring GVRP
SwitchA
SwitchB
SwitchC
Branch of
company A
Company A
Company B
GE1/0/1
GE1/0/1
GE1/0/2
GE1/0/1
GE1/0/2
GE1/0/2
Company A
Company A
Configuration Roadmap
The configuration roadmap is as follows:
1. Enable GVRP globally.
2. Set the link type of interfaces to trunk.
3. Enable GVRP on interfaces.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 6 GVRP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
338