7.10 Configuring MAC Address Flapping Detection
This section describes how to configure MAC address flapping detection.
7.11 Configuring the S7700 to Discard Packets with an All-0 MAC Address
You can configure the S7700 to discard packets with an all-0 source or destination MAC address.
7.12 Enabling MAC Address Triggered ARP Entry Update
The MAC address triggered ARP entry update function enables the S7700 to update the
corresponding ARP entry when the outbound interface in a MAC address entry changes.
7.13 Enabling Port Bridge
The port bridge function enables an interface to process packets in which the source and
destination MAC addresses are the same.
7.14 Configuration Examples
This section provides several examples for the configuration of the MAC address table.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 7 MAC Address Table Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
343
To Next Page
Loading...
