Huawei quidway s7700 - Adding Member Interfaces to an Eth-Trunk

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id
The Eth-Trunk view is displayed.
Step 3 Run:
mode manual [ load-balance ]
The operation mode of the Eth-Trunk is set to load balancing.
By default, an Eth-Trunk works in manual load balancing mode.
If the local device is configured with the Eth-Trunk in manual load balancing mode, you need
to configure the Eth-Trunk in manual load balancing mode on the peer device.
----End
2.3.3 Adding Member Interfaces to an Eth-Trunk
Context
Do as follows on the S7700 where you need to configure member interfaces of an Eth-Trunk.
Procedure
l Configuration in the Eth-Trunk interface view
1. Run:
system-view
The system view is displayed.
2. Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
3. Run:
trunkport interface-type { interface-number1 [ to interface-number2 ] }
&<1-8>
Member interfaces are added to the Eth-Trunk.
l Configuration in the member interface view
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 2 Link Aggregation Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
21