Huawei quidway s7700 - Enabling STP;RSTP; Checking the Configuration

Step 2 Run:
interface interface-type interface-number
The Ethernet interface view is displayed.
Step 3 Run:
stp port priority priority
The port priority is configured.
The default priority value of a port on a switching device is 128.
----End
8.2.6 Enabling STP/RSTP
After STP/RSTP is enabled, spanning trees are calculated.
Context
After STP/RSTP is enabled on a ring network, STP/RSTP immediately calculates spanning trees
on the network. Configurations on the switching device, such as the switching device priority
and port priority, will affect spanning tree calculation. Any change of the configurations may
cause network flapping. Therefore, to ensure rapid and stable spanning tree calculation, perform
basic configurations on the switching device and its ports and enable STP/RSTP.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
stp enable
STP/RSTP is enabled on the switching device.
By default, the STP/RSTP function is enabled on a S7700.
----End
8.2.7 Checking the Configuration
After basic STP/RSTP functions are configured, you can view the information such as the port
role and port status to check whether the spanning tree calculation is correctly performed.
Prerequisite
All configurations of basic STP/RSTP functions are complete.
Procedure
l Run the display stp [ interface interface-typeinterface-number ] [ brief ] command to view
spanning-tree status and statistics.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 8 STP/RSTP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
393