EasyManua.ls Logo

Huawei quidway s7700 - Page 45

Huawei quidway s7700
648 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Procedure
l Configuration in the Eth-Trunk interface view
1. Run:
system-view
The system view is displayed.
2. Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
3. Run:
trunkport interface-type { interface-number1 [ to interface-number2 ] }
&<1-8>
Member interfaces are added to the Eth-Trunk.
l Configuration in the member interface view
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
eth-trunk trunk-id
The interface is added to the Eth-Trunk.
When adding an interface to an Eth-Trunk, pay attention to the following points:
– An Eth-Trunk contains a maximum of eight member interfaces.
– A member interface cannot be configured with any service or static MAC address.
– When adding an interface to an Eth-Trunk, ensure that the interface is a hybrid interface,
which is the default interface type.
– An Eth-Trunk cannot be nested, that is, its member interfaces cannot be Eth-Trunk.
– An Ethernet interface can be added to only one Eth-Trunk interface. To add the Ethernet
interface to another Eth-Trunk, delete the Ethernet interface from the current Eth-Trunk
first.
– The member interfaces of an Eth-Trunk must be of the same type. For example, the FE
interface and the GE interface cannot be added to the same Eth-Trunk.
– Ethernet interfaces on different LPUs can be added to the same Eth-Trunk.
– The peer interface directly connected to the Eth-Trunk on the local end must also be
added to an Eth-Trunk; otherwise, the two ends cannot communicate.
– When the rates of member interfaces are different, the interfaces with a smaller rate may
be congested, and packets may be lost.
– After an interface is added to an Eth-Trunk, MAC address learning is performed by the
Eth-Trunk rather than the member interfaces.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 2 Link Aggregation Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
28

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals