Huawei quidway s7700 - Example for Configuring SEP Multi-Instance

#
return
l Configuration file of PE4
#
sysname PE4
#
vlan batch 5 to 6 100 200
#
rrpp enable
#
stp region-configuration
instance 1 vlan 5 to 6 100
active region-configuration
#
rrpp domain 1
control-vlan 5
protected-vlan reference-instance 1
ring 1 node-mode transit primary-port GigabitEthernet 1/0/1 secondary-port
GigabitEthernet 1/0/2 level 0
ring 1 enable
#
interface GigabitEthernet1/0/1
port link-type trunk
port trunk allow-pass vlan 100
stp disable
#
interface GigabitEthernet1/0/2
port link-type trunk
port trunk allow-pass vlan 5 to 6 100 200
stp disable
#
interface GigabitEthernet1/0/3
port default vlan 200
port trunk allow-pass vlan 5 to 6 100
#
return
l Configuration file of CE1
#
sysname CE1
#
vlan batch 100
#
interface GigabitEthernet1/0/1
port link-type trunk
port trunk allow-pass vlan 100
#
return
10.7.5 Example for Configuring SEP Multi-Instance
On a closed ring network, two SEP segments are configured to process different VLAN services,
implement load balancing, and provide link backup.
Networking Requirements
In common SEP networking, a physical ring can be configured with only one SEP segment in
which only one interface can be blocked. If an interface in the SEP segment in the complete state
is blocked, all user data is transmitted only along the path where the primary edge interface is
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 10 SEP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
561