Huawei quidway s7700 - Dividing a LAN into Vlans Based on Ports

Data Preparation
To dividing a LAN into VLANs, you need the following data.
No. Data
1 VLAN ID, number of each Ethernet port to be added to the VLAN, and (optional)
attributes of Ethernet ports
2 (Optional) Priority of each Ethernet port
3 MAC address and IP address mapped to the VLAN and (optional) number of the
Ethernet port added to a VLAN based on its MAC and IP addresses
4 MAC address mapped to the VLAN and (optional) 802.1p priority value related
to the MAC address
5 (Optional) IP subnet index, IP address mapped to the VLAN, and (optional)
802.1p priority value related to the IP address or network segment
6 (Optional) Protocol template index, protocol type mapped to the VLAN, and
(optional) 802.1p priority value related to the protocol
3.3.2 Dividing a LAN into VLANs Based on Ports
Dividing a LAN into VLANs based on ports is the most simple and effective VLAN division
mode.
Context
After VLANs are configured based on ports, the VLANs can process tagged and untagged frames
in the following manners:
l After receiving an untagged frame, a port adds the PVID to the frame, searches the MAC
address table for an outbound port, and sends the tagged frame from the outbound port.
l After a port receives a tagged frame, it checks the VLAN ID carried in the frame:
– If the port allows frames with the specified VLAN ID to pass through, it forwards the
frame.
– If the port does not allow frames with the specified VLAN ID to pass through, it discards
the frame.
The configuration roadmap is as follows:
1. Create VLANs.
2. Configure the port type and features.
(1) Configure the port type (access, trunk, hybrid, or QinQ).
3. Add ports to VLANs.
Procedure
Step 1 Run:
system-view
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 3 VLAN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
78