● Output connector with crimped cables on signal pins: The connector model is
Huafeng DY98-01Z02. Crimp the communications cable (prepared by the
customer), connect the cable to the metal jack, and then insert the cable into
the corresponding pin of the output connector.
Figure 2-7 Output connector (DY98-01Z03, output connector with welded board
on signal pins)
Figure 2-8 Output connector (DY98-01Z02, output connector with crimped cables
on signal pins)
Table 2-13 Output connector denition
Pin
Item Function
1, 2 1000 V DC– Negative output (pins 1 and 2
must be connected in parallel)
3, 4 1000 V DC+ Positive output (pins 3 and 4
must be connected in parallel)
5 CANBH CAN high-level signal
6 CANBL CAN low-level signal
7 CANBH CAN high-level signal
8 CANBL CAN low-level signal
9 CAN_GND Signal ground
10 LINK_CHECK_OK Insertion and removal control
11 URGENT_TURN_OFF+ Emergency shutdown+
12 URGENT_TURN_OFF– Emergency shutdown–
R100030G1 Charging Module
User Manual 2 Product Description
Issue 05 (2021-11-16) Copyright © Huawei Digital Power Technologies Co., Ltd. 19
To Next Page
Loading...
