Figure 6-8 Securing a charging module (side mounting)
Step 4 Disconnect the ground cable of the ESD wrist strap, and remove the ESD wrist
strap and ESD gloves.
Step 5 After the installation is complete, the system monitoring module sends a startup
command to the charging module. Check that the green indicator on the charging
module turns on to ensure normal running.
Step 6 Set the hardware address of the charging module if grouping is required, as
described in "Button Operations."
----End
R100030G1 Charging Module
User Manual 6 Maintenance
Issue 05 (2021-11-16) Copyright © Huawei Digital Power Technologies Co., Ltd. 40
To Next Page
Loading...
